See the Supply List for beads and tools you can purchase here. You will also need:
Silver jump rings - 3
Silver earring wires - 2
Chain, ribbon, or cord
Download the PDF for the Zebra Jewelry Set Project Pattern. You will use the small circle pegboard to create your projects. If you are using a clear pegboard, slide the actual-size pattern underneath it. Place your beads following the pattern.
Ask an adult to fuse your designs. Place your pegboard on a flat, heat-safe surface. Set a household iron to the medium setting. Place ironing paper over the pegboard. In a circular motion, begin to iron the project. When ironed properly, the beads will still have open centers. DO NOT OVER-IRON as this will cause the beads to close and can make assembly of your project more challenging. Let the design cool.
Remove the paper and bead design from the pegboard. Flip the design over to expose the non-fused side. Repeat the fusing. Let cool completely. Once the design is cool, peel off the ironing paper. Your pegboards and ironing paper are reusable.
Note: Beads need heat for about 10-20 seconds per side to fuse evenly. Lift the paper occasionally to see how the beads are fusing. Additional heating time may be required.
ASSEMBLY: Put a jump ring through the top zebra bead for each earring. Add the earring wire.
Put a jump ring through one of the black beads on the pendant. Thread a thin silver chain, black satin ribbon or cord through the jump ring to create the necklace.