To order by phone, inquire about an order, or request an exchange/refund, call:



For questions about product use, instructions or to request replacement parts or materials call toll-free:



Order Status

Contact Us

Shipping Information

Return & Exchange Policy



Fancy Floral Necklace
Fancy Floral Necklace
Fancy Floral Necklace
Fancy Floral Necklace
Item(s) added to the shopping cart!
Item(s) added to your Favorites!

Fancy Floral Necklace

★★★★★ ★★★★★

This beautiful floral necklace is fancy enough for the Academy Awards! Easy and quick to make with Perler beads in your favorite colors.

Step: 1

Bead Colors Needed:

  • Light Pink - 54
  • Bubblegum - 21
  • Cranapple - 3
  • Cream - 84
  • Cheddar - 40
  • Rust - 6
  • Toothpaste - 30

See the Supply List for beads and tools you can purchase here. You will also need:

  • Ribbon: 1/4 inch wide shiny gold, 28 inch length
  • Craft glue
Step: 2

Download the PDF for the Fancy Floral Necklace Project Pattern. You will use the large hexagon pegboard for your project. If you are using a clear pegboard, slide the actual-size pattern underneath it. Place the beads for the project.

Step: 3

Ask an adult to fuse your designs. Place your pegboard on a flat, heat-safe surface. Set a household iron to the medium setting. Place ironing paper over the pegboard. In a circular motion, begin to iron the project. When ironed properly, the beads will still have open centers. Let the design cool.

Step: 4

Remove the paper and bead design from the pegboard. Flip the design over to expose the non-fused side. Repeat step two. Let cool completely. Once the design is cool, peel off the ironing paper. Your pegboards and ironing paper are reusable.

Note: Beads need heat for about 10-20 seconds per side to fuse evenly. Lift the paper occasionally to see how the beads are fusing. Additional heating time may be required.

Step: 5

ASSEMBLY: Cut your ribbon in half to make each piece 14 inches. Thread the ribbon ends from front to back through the top hole of your design where shown and pull an inch through. Glue this to the back side of the ribbon. Tie ends into a bow.