Bead Colors Needed:
- Light Pink - 108
- Pastel Yellow - 163
- Purple - 24
- White - 72
See the Supply List for beads and tools you can purchase here.
Download the PDF for the 3D Dollhouse Table and Chair Project Pattern. You will use the large square pegboard for your project. If you’re using a clear pegboard, slide the actual-size pattern underneath it. Place all the beads for the design.
Ask an adult to fuse your designs. Place your pegboard on a flat, heat-safe surface. Set a household iron to the medium setting. Place ironing paper over the pegboard. In a circular motion, begin to iron the project. When ironed properly, the beads will still have open centers. DO NOT OVER-IRON as this will cause the beads to close and can make assembly of your project more challenging. Let the design cool.
Remove the paper and bead design from the pegboard. Flip the design over to expose the non-fused side. Repeat step two. Let cool completely. Once the design is cool, peel off the ironing paper. Your pegboards and ironing paper are reusable.
Note: Beads need heat for about 10-20 seconds per side to fuse evenly. Lift the paper occasionally to see how the beads are fusing. Additional heating time may be required.
ASSEMBLY: All assembly is tab and slot. For the chair, insert the tab of the chair back into the slot on the seat with the pieces at right angles to each other. Slide the chair legs onto the assembled seat/back.
For the table, turn the leg pieces at right angles to each other and align them slot to slot. Slide together. Then slide the table top onto the assembled legs.