Bead Colors Needed:
- Light Pink - 137
- Light Green - 118
- Purple - 25
- White - 763
See the Supply List for beads and tools you can purchase here.
Download the PDF for the 3D Dollhouse Vanity and Chair Project Pattern. You will use the large square pegboard for your project. If you’re using a clear pegboard, slide the actual-size pattern underneath it. Place all the beads for the design.
Ask an adult to fuse your designs. Place your pegboard on a flat, heat-safe surface. Set a household iron to the medium setting. Place ironing paper over the pegboard. In a circular motion, begin to iron the project. When ironed properly, the beads will still have open centers. DO NOT OVER-IRON as this will cause the beads to close and can make assembly of your project more challenging. Let the design cool.
Remove the paper and bead design from the pegboard. Flip the design over to expose the non-fused side. Repeat step two. Let cool completely. Once the design is cool, peel off the ironing paper. Your pegboards and ironing paper are reusable.
Note: Beads need heat for about 10-20 seconds per side to fuse evenly. Lift the paper occasionally to see how the beads are fusing. Additional heating time may be required.
ASSEMBLY: All assembly is tab and slot. For the vanity, align the tabs on the vanity top with the slots in the vanity back and slide together with pieces at right angles to each other.
Next, connect the sides and post to the front.
Connect the assembled back/top section to the front/sides section.
For the chair, connect the back to the seat and then add the sides.