Bead Colors Needed:
- Red - 515
- Black - 68
- White - 150
- Clear - 6
See the Supply List for beads and tools you can purchase here.
Download the PDF for the Red Raider Project Pattern. You will use the large square and small hexagon pegboards for your project. If you are using a clear pegboard, slide the actual-size pattern underneath it. Place your beads following the pattern.
Ask an adult to fuse your designs. Place your pegboard on a flat, heat-safe surface. Set a household iron to the medium setting. Place ironing paper over the pegboard. In a circular motion, begin to iron the project. When ironed properly, the beads will still have open centers. DO NOT OVER-IRON as this will cause the beads to close and can make assembly of your project more challenging. Let the design cool.
Remove the paper and bead design from the pegboard. Flip the design over to expose the non-fused side. Repeat the fusing. Let cool completely. Once the design is cool, peel off the ironing paper. Your pegboards and ironing paper are reusable.
Note: Beads need heat for about 10-20 seconds per side to fuse evenly. Lift the paper occasionally to see how the beads are fusing. Additional heating time may be required.
ASSEMBLY: GENTLY slide the bottom wing through the body of the plane.
Attach the wing struts to the upper wing.
Attach the upper wing to the lower wing.
Slide on the propeller and tail fin.
GENTLY push the wheels onto the landing gear segment.
Slide the whole assembly onto the plane.