To order by phone, inquire about an order, or request an exchange/refund, call:



For questions about product use, instructions or to request replacement parts or materials call toll-free:



Order Status

Contact Us

Shipping Information

Return & Exchange Policy



Pineapple Keychain
Pineapple Keychain
Item(s) added to the shopping cart!
Item(s) added to your Favorites!

Pineapple Keychain

★★★★★ ★★★★★

This fun pineapple keychain is easy to make from Perler beads. Add it to your backpack and you'll always be able to find your key!

Step: 1

Bead Colors Needed:

  • Yellow - 149
  • Kiwi Lime - 41
  • Tan - 30

You will also need:

  • Large square pegboard
  • Iron and ironing paper
  • Key ring with a jump ring
  • Flat nose pliers

See the Supply List for beads and tools you can purchase here.

Step: 2

Download the PDF for the Pineapple Keychain Project Pattern. You will use the large square pegboard to create your project. If you are using a clear pegboard, slide the actual-size pattern underneath it. Place your beads following the pattern.

Step: 3

Ask an adult to fuse your designs. Place your pegboard on a flat, heat-safe surface. Set a household iron to the medium setting. Place ironing paper over the pegboard. In a circular motion, begin to iron the project. When ironed properly, the beads will still have open centers. DO NOT OVER-IRON as this will cause the beads to close and can make assembly of your project more challenging. Let the design cool.

Step: 4

Remove the paper and bead design from the pegboard. Flip the design over to expose the non-fused side. Repeat the fusing. Let cool completely. Once the design is cool, peel off the ironing paper. Your pegboards and ironing paper are reusable.

Note: Beads need heat for about 10-20 seconds per side to fuse evenly. Lift the paper occasionally to see how the beads are fusing. Additional heating time may be required.

Step: 5

ASSEMBLY: Use flat nose pliers to grasp and open the jump ring. Don’t pull outward to separate the ends; instead, open the ring by twisting the ends in opposite directions.

Step: 6

Slide the jump ring through the bead in the center top of the design, then close the ring by twisting the ends back together.